How to Connect Two Wireless Routers to One DSL Line

Video of the Day

How To Use Two Wireless Routers In The Same House
What I did was setup two Linksys routers using ddwrt custom firmware. This is useful for file sharing and other purposes. By continuing to use this site, you are consenting to our use of cookies. This is not a repeater, it's a second AP plug directly into the first's hub. After you save this setting, the router administration interface will probably stop working.

Using two routers for the same SSID

How to Run Two Routers Off One Cable Connection

Granted, this is if Cox allows you to have 2 modems in the same house. And if they do, I'm betting they won't let that go for free.

If you just want a dedicated ethernet connection from the router downstairs, then you just need to figure out how to get a long ethernet cable upstairs to your place OR investigate ethernet over power line. I don't know how the latter works, so you'll have to do that research on your own. The former is pretty easy besides routing the ethernet cable around the house so it doesn't look too bad.

I'm fairly sure that cheapandtacky is right: From your OP it sounded like you didn't want your own service, but rather to piggyback onto what is already there. It is worth giving the provider a call to see if they can offer what you want but from my limited knowledge of how it works, I seriously doubt it. To me, the "right" way to do this is to run cat5 from the existing router up to the second floor possibly beside or even replacing the existing coax.

Obviously you'd need permission to do this; your landlord should consider it a value-add though: Also, wireless may not be as terrible as you think; it totally depends on the router and the location i.

Worth a test in my opinion. The idea that gaming over wifi is terrible is a bit of a myth though there certainly can be such a thing as an unreliable connection: So check if your ping time to the wifi router is consistently low; hopefully there aren't a ton of other nearby networks or lots of computers on the network. Connect the router to a power source if it isn't currently connected to one.

Insert an Ethernet cable into an out port on the wireless modem and insert it into the Ethernet port on a computer.

Although the wireless modem is made to be wireless, you do need to activate it through a wired connection. Launch the Internet browser on the computer connected to the wireless router. Look on the wireless router and you are going to find an "Http: Type this number into the search bar and press Enter. There IP Address is Message 1 of 6. For the inexperienced, the golden rule is one network, one router - anytime you have two routers and you can make them do what you want, chalk it up to inexperience, and get rid of one.

What you should have been using is not two routers, but a router and a wireless access point - your options are Get rid of one router best option Configure one router to act as a wireless access point - which can be done by following the steps in the link you provided. Give a man a fish, feed him for a day Teach a man to fish, feed him for life. Message 2 of 6. What steps are needed to be performed on the WDNR to accomplish the instructions based on the link I provided?

What You Need To Make Two Wireless Routers Work Together

Leave a Reply